Baron Chrome Shop_REAR LICENSE MOUNT w_LED LICENSE FRAME - Manual

Page: 1 BA-3150WR
Warrior License Holder w/ LED Frame
2002-up Yamaha Warrior
Our install guides provide a basic outline on the proper installation of our
products. Further tuning and/or fitment may be required. Baron bears no
responsibility on installation costs associated with this product.
Revision: 1.5 - 09/28/2010
INCLUDED IN THE KIT:
1-License Holder (black)
1- LED Plate Frame (Chrome)
4-M5 stainless hex head screws
2-M6x10 stainless flathead screws
2-M6 nyloc nuts
2-M6 stainless fender washers
4-M5 stainless flat washers
TOOLS REQUIRED:
M4 Allen Wrench
M5 Allen Wrench
Flathead Screwdriver
Phillips Screwdriver
M8 Socket or Wrench
M10 Socket or Wrench
INSTRUCTIONS:
This product is not intended for use with stock turn signal assemblies. If using marker lights or other
aftermarket turn signals, install according to instructions supplied by manufacturer. Bolt to tabs provided and
plug into wire harness where stock lamps were disconnected. If you do not plan on using tabs for marker lamps
they may be trimmed off before installation.
1. Remove rear fender from bike.
2. Remove plastic license holder/sub fender from fender.
3. Remove tail lamp from plastic license holder/sub fender. You will need to trim off the molded-in plastic
post from rear of stock tail lamp to facilitate flush mounting of light to Baron bracket.
4. Install tail lamp onto new Baron License Holder using stock sheet metal screws
5. Install license plate into new license holder using the chrome frame and the M5 hex screws and washers.
(Note: some state plates may require trimming). LED frame wiring should run under the plate. Plate
screws need to be snug, but not too tight as to crush the plate wiring.
6. Place tail lamp bezel around tail lamp.
7. Install new license holder into fender and secure with two washers and nuts on existing studs on top, and
two flathead screws in existing nuts on each side. Tighten securely.
8. Splice LED Plate frame wires into stock wiring harness
9. Plug in tail lamp.
10. Check for proper operation of tail and brake lamps, and turn signals if used.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]