Baron Footrest & Controls_RIDER LONG & SHORT BOARD BRACKETS - Kawasaki Vulcan - Manual

Page: 1 BA-7072-05
Longboard Mounts
Kawasaki VN1600 Classic/Nomad/VN2000/VN900
Revision: 1.1 - 02/19/2010
INCLUDED IN THE KIT:
(2) - M6 Set Screws (installed)
(4) - M5 Set Screws (installed)
(4) - M8x20 Cap Head Screws
(2) - Longboard Mounts
INSTRUCTIONS:
NOTE: We recommend the use of blue Loctite on all fasteners/mounting hardware.
Unhook spring from underside of stock floorboard.
Remove E-clips from stock pivot pins and remove pins. Retain pin and E-clip as they will be reused. The
spring will not be reused.
Install new floorboard mounts to frame where stock boards were removed, using hardware removed in
previous step.
Attach new Longboards onto mounting brackets in desired position using supplied M8 cap-head screws.
NOTE: not all positions may be usable in all applications.
After mounting screws are tightened, tighten set screw on each end of mount bracket to hold mounting
screws in place.
Adjust heel shifter so it does not touch floorboard during downshifts. NOTE: heel shifters are removable
on most models.
Use set screw on bottom of mount brackets to set desired angle to boards.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]