Baron Grips & Risers_KICKBACK RISERS - BLACK - Manual (Page 2)

Page: 2 BA-7410U & BA-7410B
KICKBACK RISERS - FOR SELECT MODELS OF
YAMAHA-HONDA-KAWASAKI-SUZUKI &
HARLEY-DAVIDSON
5. Mount the riser with its stud through the top of the triple tree. Install the flat washer and then the Nylock nut
on each stud and thread them on but do not yet tighten completely.
6. Install handlebar into the risers, lining up the knurling evenly left to right and then install riser cap and its
bolts one side at a time and tighten them loosely into position.
7. With the handlebar in place this aligns the risers so they are square in the triple tree. Now you may tighten
the Nylock nuts on the riser studs firmly in place.
8. Adjust the rotation of the handlebar to where they are comfortable for you.
SUGGESTION: When adjusting the rotation of the bars it is important for comfort and control that the
hand/wrist position be slightly downhill rather than having the ends of the bar parallel to the ground.
9. When you are satisfied with the rotation tighten the top clamp bolts to hold the bars in place.
TESTING TURNING RADIUS: VERY CAUTIOUSLY turn your handlebars full left and full right to be sure
the bars, controls or control lines do not hit your fuel tank. At the same time it is very important to watch the
risers carefully to be sure they do not contact the dash. If there is any contact with the handlebar you must
rotate the bars upward until there is no more contact. If there is contact with the fuel tank you may not be able
to use these risers. However you should check to confirm the fuel tank and dash are installed properly and are
pulled to the rear of the bike as far as possible. In some cases it may be possible to place a thick shim (washer)
between the riser base and the top of the triple tree to raise the riser to clear the dash.
10. Now firmly tighten the risers' tops by tightening the forward-most bolts first until the clamp and riser base
touch lightly touch. Then tighten the rear bolts firmly and test the bars to be sure they do not rotate. Be sure all
bolts are tightened firmly and evenly.
SUGGESTION: Some bikes come with rubber riser dampers which reduce vibration. With the added length of
the riser you my find more bar movement than you prefer. In this case we suggest you add a large Fender
washer the diameter of the damper, placing it on the riser bolt against the underside of the triple tree, then
install the supplied washer and Nylock nuts and tighten. This will reduce the damper flexing.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]