Baron Air & Fuel_AIR INJECTION SYSTEM KIT Honda Models - Manual

Page: 1 BA-2561-00
REED VALVE BLOCK OFF KIT - Honda VTX
We recommend the use of Blue Loctite® on all fasteners and mounting
hardware. Our install guides provide a basic outline on the proper installation
of our products. Further tuning and/or fitment may be required. Baron bears
no responsibility on installation costs associated with this product.
Revision: 2.1 - 02/23/2010
Install Time: 1 hour
INCLUDED IN THE KIT:
(2) - Block off plates
(1) 1/2" Rubber cap
(1) 2mm Rubber cap
TOOLS REQUIRED:
Assorted wrenches
Assorted Allen wrenches
Factory Service Manual
INSTRUCTIONS:
Please read ALL of the instructions BEFORE beginning the installation.
NOTE: We highly recommend the use of the factory service manual.
1. Remove the fuel tank per Honda service manual instructions.
2. Remove the air filter box.
3. Find rubber hose going to rear of air box and pull it off. Cap it with supplied rubber cap and the stock
clamp.
4. Follow the hose you just disconnected up to the top of front cylinder and you will find the PAIR valve
solenoid.
5. Unplug the electrical connection going to the PAIR solenoid.(Some models may not have electrical leads).
6. There are hoses that run from the PAIR solenoid to the top of each cylinder. Follow those hoses the pull them
off their fittings.
7. The entire PAIR solenoid with all its hoses attached can be removed from the motorcycle.
8. Remove the fitting from the top of each cylinder where the hoses were just removed and replace them with
supplied block-off plates. Reuse stock screws for this.
9. If your carburetor or throttle body has a vacuum line running to its base, and the other end of the line was
connected to the pair valve you will use the 2mm Cap (Supplied) to cap the spigot at the base of the carburetor.
10. Reinstall the air filter.
11. Reinstall the fuel tank per service manual instructions.
Note: No adjustment is needed to the fuel injection system because of this modification
WARNING: This product is not DOT/EPA approved and is not for use on public highways. This product is
intended only for offroad/closed-course racing use only.
This product is intended for installation on Honda VTX only.
Baron accepts no responsibility for any damage incurred when installing this product on any other motorcycle.
Our install guides provide a basic outline on the proper installation of our products. Further tuning and/or
fitment may be required. Barons bears no responsibility on installation costs associated with this product.
© 2013 Barons Custom Accessories
5221 Oceanus Drive Huntington Beach, CA 92649 (925)583-2499 - Ph. (714)901-0520 - Fax www.baronscustom.com [email protected]