Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 49)

7. Rest Platform
PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series 49
Install Ladder Support Brackets
On the open side of the rest platform, where the ladder extends through the opening, four (4) brackets
must be installed to the ladder. Two (2) brackets will be installed to the end of the ladder on the deck
plate side.
1. Install ladder support brackets (LAD1648BLH and LAD1648BRH) to the rest platform cross channel
(RSP482CCX) using 3/8" x 1" HHCS bolts (S-7469) and 3/8" flange nuts (S-10028).
2. One set of brackets will attach to the ends of the ladder and the other will attach along the middle.
Fasten ladders to brackets using 1/2" x 1" HHCS bolts (S-7935) and 1/2" flange nuts (S-8506).
(See Figure 7N.)
Figure 7N
3. At the end of the through ladder, secure the end of the ladder to the handrail using ladder support
rest platform brackets (RP1648LS). Fasten the brackets to the ladder using 1/2" x 1" HHCS bolts
(S-7935) and 1/2" flange nuts (S-8506).
4. Secure the brackets to the handrail using 1/4" x 1-1/2" U-bolts (S-10136) and nuts. (See Figure 7O
on Page 50.)