Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1842 - Manual (Page 30)

6. Tie Angles, Ladders and Safety Cages
30 PNEG-1842 42"-48" Bucket Elevator Platform and Ladder “X” Series
Attach Ladder Support Brackets to Tie Angles for 42"
1. For 42" Ladder Brackets: Mount the upper left and upper right hand brackets (LAD1648TLH2 and
LAD1648TRH2) to the top tie angles.
2. Mount the lower left and lower right hand brackets (LAD1648TLH1 and LAD1648TRH1) to the bottom
tie angles.
3. Fasten flanges of brackets and brackets to tie angles using 3/8" x 1" HHCS bolts (S-7469) and
3/8" flange nuts (S-968). (See Figure 6N below, Figure 6O and Figure 6P on Page 31.)
NOTE: You will only use one set of brackets, either the up-leg set or the down-leg set depending on
your ladder location.
Figure 6N 42" Ladder Support Bracket Parts