Xerox WorkCentre Pro 215 - Manual (Page 19)

12
Power Reduction / Auto Clear
Power Reduction Modes automatically reduce power consumed by the Pro 215 when the Pro 215
has not been used for a set period of time. There are two modes of power reduction; Power Save ,
and Power Shut-off.
Power Save Mode – The Ready Indicator will flash and the other indicators will remain on. To
copy from the Power Save mode select the desired features and press Start. The copies will be
made automatically.
Power Shut-Off Mode – When the Pro 215 enters the power shut-off mode the Ready Indicator will
flash and the other indicators will turn off. To copy from the power shut-off mode, press the Start
button, then, select the desired features and press Start again. The copies will be made
automatically.
Auto Clear – This Pro 215 is enabled at the factory to return to the Normal Copy Mode
approximately one minute after a job is completed. Unless otherwise programmed, the Normal
copy Mode settings are as follows:
•
Copy Quality – Auto
•
Copy Lighter/Darker – Normal
•
Priority Tray – Tray 1
•
Priority Magnification – 100%
•
Quantity Selected – 1
Note: Time periods for the Power Shut-Off, Power Save, and Auto Clear modes can be modified to
meet your specific copying needs. Refer to Customizing Your Pro 215 section of this User Guide
for information about changing these settings.
Auto Copy Function
This function provides the ability to program a copy job while the copier is warming up, or to pause a
print job to enable copying.
1. Program the copy job.
2. Press Start.
• The current page will be completed if printing is in process.
3. When the copy job is completed, press the On-line/Off-line button to immediately return to the
print job.