Velleman Central Management System - Manual (Page 8)

5
2.3 Network Setting
Note: It’s recommended to have the qualified installer to plan and configure the
network setting.
Step1: Click “ ” to show the “General setting and utilities” dialog box, and click “Remote
Config” twice to enter the setting page.
Step2: Select “Network” to make network settings based on your network environment.
There are three network connection types: Static IP, PPPOE, and DHCP.
Note: The device doesn’t support POE router or hub.
For Static IP:
a) Enter the information of “Server IP”, “Gateway” and “NetMask” obtained from your ISP (Internet
Service Provider).
b) Enter the port number. The valid number ranges from 1 to 9999. The default value is 80. Typically, the
TCP port used by HTTP is 80. However in some cases, it is better to change this port number for
added flexibility or security.
c) Click “Apply”, and click “OK” to exit the setting page.
For PPPOE:
a) Go to “Network” “DDNS”, and select “default” in the “System Name” drop-down list.
b) In “Hostname”, keep the default value, i.e. the MAC address of the device, or change the name to a
meaningful one. It’s easier to memorize.
c) Note down the whole address of the device, for example, MAC000E53114389.ddns.dvrtw.com.tw.
Note: If “default” is not available, please subscribe a DDNS account from a website
which provides free DDNS service. For details, please refer to “APPENDIX 2
SUBSCRIBING DDNS SERVICES” at page 39.