VEGA VEGAMET 514… D - Manual (Page 19)

VEGAMET 514… D 19
Set-up, configuration
4.6 Set-up, configuration
4.6.1 Configuration inputs
The inputs of the signal conditioning instruments are
configured according to the ordered instrument
version. Therefore no activities from your side are
necessary. However should there be a modification
necessary, you will find some explanations and
connection examples in the following.
The signal conditioning instruments are either
connected directly to the sensors or they receive
measured data from other sensors via the DISBUS-
connection.
Connection example 1
VEGAMET 514 D
- Sensors connected directly to VEGAMET
Marking:
The sensor must be marked via its sensor
characteristics values (only hydrostatic pressure
transmitters).
Connection example 2
VEGAMET 514 VD
- Sensors connected directly to VEGAMET
Marking:
The sensor must be marked with its series
number.
Pos. A – input 1, series number 8888.8888
Pos. D – input 4, channel K1
A
D
Sensor
series
number
A
D
Sensor
characteris-
tics values
Pos. A – input 1, channel S1
Pos. D – input 4, channel K1
>>
K1
K1
S1