Installation guide, Network configuration, Wiring the network(s) – Veris Industries H8936 Install User Manual

Page 5: Network map: option 1, Network map: option 2, Next previous hold scroll

Z202662-0G

PAGE 5

09126

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

H8932/H8936

INSTALLATION GUIDE

NOTE: The manufacturer does not recommend connecting multiple network displays in series on

the downstream network.

NOTE: Other Modbus devices must respond to the “Report Slave ID” command (11h) to allow pass-

through communication from the upstream network.

NETWORK CONFIGURATION

Wiring the Network(s)

The H8932/H8936 resides on a Modbus network as a pass-through device. Unlike
most Modbus RTU devices, it is not wired in a daisy chain configuration. This allows
the user to make separate upstream and downstream networks, allowing for flexible
data retrieval, as the upstream options include RS-232 or RS-485.

Network Map: Option 1

Control Panel

or PC

Next Network Display

On to additional Network Displays

Network Display

H663/H704

Branch Circuit Monitor

H8163 with H8163-CB

Energy Meter with

Communication Board

H8035/H8036

Enercept Power Meter

H8238

Multi-Circuit Monitor

E30/E31

Panelboard Monitor

E5xCx

Power and Energy Meter

End-of-Line

Termination Resistor

100 Ohms

Upstream RS-485

RS-232

Downstream RS-485

Up to 63 (physical) or 246 (logical) devices

DOWN

SELECT

METER

ALARM

OPERATING MODE

NETWORK DISPLAY

VERIS INDUSTRIES

SETUP

NEXT

PREVIOUS

HOLD

SCROLL