Veris Technologies MSP EC and pH (1997-2008 CF card drive 1.10M) - Operating Instructions - Manual (Page 3)

Veris Technologies
Pub. #OM MSP03-1
3
Important! Read the following SAFETY PROCEDURES before operating the Veris MSP:
•
Read and understand all instructions on safety decals
•
Before filling tank with gasoline, let engine cool. Gas vapors can ignite and an explosion can occur.
• Escaping fluid under pressure can penetrate the skin causing serious injury. Avoid the hazard by
relieving pressure before disconnecting hydraulic lines. Use a piece of paper or card-board, NOT
BODY PARTS, to check for suspected leaks.
• Wear protective gloves and safety glasses or goggles when working with hydraulic and high-
pressure wash systems.
• If an accident occurs, see a doctor immediately. Any fluid injected into the skin must be surgically
removed within a few hours or gangrene may result.
• Pinch point hazard: to prevent injury, stand clear when raising or lowering any part of the Veris
MSP. Disengage automatic cycling function before working around unit.
• Install all transport locks before transporting or working underneath.
• Detach and store implements in an area where children normally do not play. Secure implement by
using blocks and supports.
•
Read Operations Manual before operating machine
•
Review safety instructions with operators before operating machine and at least annually
•
Never stand on or use tire as a step
•
Do not tow the implement on public roads without the optional light package, or without the proper
safety equipment and licensing as required by your State Department of Transportation. Always use
safety chain.
• Riders obstruct the operator’s view. They could be struck by foreign objects or thrown from the
machine.
• Never allow children to operate equipment.
•
To prevent possible electrical shock, or damage to the instrument, do not connect to any power
source greater than twelve (12) volts DC.
• Do not grease or oil implement while it is in operation.
• Disk edges are sharp. Be careful when working in this area.
• Disconnect battery ground cable (-) before servicing or adjusting electrical systems or before
welding on implement.
• Remove buildup of mud, oil or debris.
• Be prepared if a fire starts.
• Keep a first aid kit and fire extinguisher handy.