Veris Technologies MSP EC and pH (1997-2008 CF card drive 1.10M) - Operating Instructions User Manual
Page 11
Veris Technologies
Pub. #OM MSP03-1
11
Fill gasoline engine and check engine and hydraulic oil levels.
Before filling tank with gasoline, let engine cool. Gas vapors can ignite
and an explosion can occur.
Checking the hydraulic fluid level is easy thanks to a sight glass on the hydraulic reservoir. The sight
glass is located on the front of the reservoir. Maintain the hydraulic fluid within 1/2 inch (1.25 cm) of
the upper (solid black) line on the glass. Remove the threaded plug from the filler neck to add fluid.
ALWAYS CHECK HYDRAULIC FLUID LEVEL WHEN FLUID IS COLD. DO NOT OVERFILL. See
Maintenance section for specifications on oil type and quantity. Checking the hydraulic fluid level on
the GS1000 is easy thanks to a sight glass on the hydraulic reservoir. The sight glass is located on
the front of the reservoir which is in turn located on the right side (as viewed from the front) of the
machine (Fig. 3.1). Maintain the hydraulic fluid within 1/2 inch of the upper (solid black) line on the
glass. Remove the threaded plug from the filler neck (Fig 3.1) to add fluid.
hydraulic oil filler plug
hydraulic oil
sight glass
Closed center
hydraulic kit
poppet valve