Ohaus CKW WASHDOWN CHECKWEIGHING SCALES_INDICATOR Manual en - Manual (Page 38)

EN-34 CKW-55 CHECKWEIGHER
Baud Rate
This menu item is used to define Baud rate. Selections are: 300, 600, 1200, 2400, 4800, 9600
or 19200.....
Parity
This menu item is used to define parity. Selections are: None, Odd or Even.
Data Length
This menu item is used to define data length. Selections are: 7 77 77 or 8.
Stop Bit
This menu item is used define the number of stop bits. Selections are: 1 or 2.
Handshake
This menu item is used to define the flow control method used during serial communication.
Selections are: None or XON/XOFF (ON-OFF).
Type
This menu is used to define the type of serial communication interface to be used. Selections
are:
RS232 = Use only the default RS232 interface.
RS485 = Use the optional RS485/422 interface.
When RS485 is selected, the next sub-menu allows turning the address mode ON or OFF. The
selections are:
AdrON = The user may enter a two digit address from 00 to 99. The default address is
01.
AdrOFF = The interface operation will be compatible with RS422 standards with no
address requirements.
Note: During RS485 operation, the correct address must precede all data to the scale. When
the scale transmits, this same address is sent out first to identify where the data string came
from.
Alternate Command
This menu item is used to define alternate command characters for Print, Tare and Zero.
Select the command name, then enter the corresponding ASCII code for the desired character via
the numeric keypad. Then press the Yes button. Refer to Table 6-2 for a list of ASCII codes and
their equivalent characters.
Note: An ASCII code cannot be selected if already used for another function.
END
Represents the end of the menu.