Ohaus CKW WASHDOWN CHECKWEIGHING SCALES_INDICATOR Manual en - Manual (Page 33)

CKW-55 CHECKWEIGHER EN-29
Beeper Signal
This menu item is used to define when beeper sounds an (audible alert) during checkweighing.
Selections are:
O F F O F F O F F O F F O F F = Beeper does not sound.
Accept = Beeper sounds when the weighed value is within the Accept range
(corresponding to green LED bar graph area).
Under = Beeper sounds when the weighed value is below the minimum acceptable
range (corresponding to yellow LED bar graph area)*.
Over = Beeper sounds when the weighed value exceeds the maximum acceptable
range (corresponding to red LED bar graph area).
Under-Over= Beeper sounds when the weighed value is outside of the Accept range
(U-O)
(corresponding to the yellow and red LED bar graph areas)*.
*Note: When under is indicated, the beeper signal does not sound when the pan is cleared.
Weight Display Signal
This menu item is used to define the checkweigh conditions when the LED weight display flashes
as a visual alert during checkweighing.
Selections are:
O F F O F F O F F O F F O F F = LED weight display does not flash in any checkweigh condition.
Accept = LED weight display flashes when the weighed value is within the Accept
range (corresponding to green LED bar graph area).
Under = LED weight display flashes only when the weighed value is below the
minimum acceptable range (corresponding to yellow LED bar graph area)*.
Over = LED weight display flashes only when the weighed value exceeds the
maximum acceptable range (corresponding to red LED bar graph area).
Under-Over= LED weight display flashes when the weighed value is outside of the Accept
(U-O)
range (corresponding to the yellow and red LED bar graph areas)*.
*Note: When under is indicated, the display signal does not flash when the pan is cleared.