EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 47)

2.5. Server Maintenance
2.5.1. Chapter Contents
The table below presents the topics of this section and shows whether the described
features are available from the web-based interface and/or from the server-based
interface.
Commands Page Server-Based Web-Based
"Rebooting the EVS Server" 2.5.2 Yes No
"Hardware Check" 2.5.3 Yes No
"Clearing Video Disks" 2.5.4 Yes No
"Calibrating a Touch Screen" 2.5.5 Yes No
"Importing and Exporting Keyword Files" 2.5.6 Yes No
"Exporting Log Files" 2.5.7 Yes No
2.5.2. Rebooting the EVS Server
To reboot the EVS server is not running in a given configuration, press B from the
Multicam Setup window, then RIGHT ARROW and ENTER to validate the action.
To reboot the EVS server when it is running in a given configuration, press ALT+Q when
you are in the Clip or Playlist page, then press ENTER to confirm the action.
2.5.3. Hardware Check
Overview on the Hardware Check
Purpose
During the hardware check, the following actions are performed:
• Retrieving and checking relevant information related to the various boards installed on
the EVS server
• Verifying the validity of the data recorded on the video disk array
The hardware check is only available in the server-based application.
Tip
Hardware check is also used to rebuild the video and audio information after
replacing a faulty disk.
37 2. Multicam Setup
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B