EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 214)

Aux track output
Description Specifies to which audio outputs the auxiliary track of the
playlist will be played out.
Values The following values are possible:
• PRV:
The auxiliary track will use the audio outputs normally
assigned to the PRV channel. If no PRV channel is
available, the Aux Track will not be assigned to any audio
output.
• PRV&7-8/15-16:
The auxiliary track will use the audio outputs normally
assigned to the PRV channel if there is one, plus all the
audio outputs from 7-8/15-16 that have not yet been
assigned to another channel. Use this option if you need an
auxiliary track without PRV channel available.
• PGM:
The auxiliary track will use the audio outputs normally
assigned to the PGM channel.
Default value PRV
3.9.11. EVS Controller Settings
Introduction
The EVS Controller settings gather:
◦ Settings related to the behavior of the keys, lever or jog of the Remote Panel.
◦ Settings associated to XFile or the EVS server itself.
Warning
Most of the settings are only available or applicable with base configurations
associated to the use of an EVS Remote Panel (LSM Remote, XSense
Remote).
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦ on page 4 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Operational setup menu of the Remote Control Panel (9.X).
XT2+ Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 204