EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 179)

3.8.2. GPI Settings
Introduction
The GPI Settings allow specifying the settings related to the GPI inputs and outputs
features.
These fields are available in the following interfaces:
• in the Multicam Configuration window, GPI tab.
• in the Technical menu of the Remote Control Panel (T6.X).
The following screenshot presents the settings page of the GPI tab in the server-based
application and highlights the GPI Settings area.
Note
If the TTL GPIs set as GPIs parameter is set to In, then the display looks like
the illustration above with 8 GPIs IN and 4 GPIs OUT lines.
If it is set to Out, then the display is reorganized to expose 4 GPIs IN and 8 GPIs
OUT lines.
GPI Types and Functions
There are 3 types of GPIs available to be used on the servers:
• The input lines 1 to 4 are opto-isolated inputs.
• The output lines 1 to 4 are relay outputs.
• The GPIs TTL lines can be configured as 4 TTL inputs or 4 TTL outputs, in both cases
numbered from 5 to 8.
According to the protocol you are using, the following functions are available and can be
assigned to the GPIs lines as described hereunder in the Function parameter.
• AVSP: Play, Stop, Still, Recue, GotoClipIN, GotoClipOUT, Next, Skip.
• Sony: Play, Pause, Recue, Previous, Next, Skip.
169 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B