EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 198)

Timeline Receive page
Description Specifies on which page(s) the clips automatically created in
timeline mode as part of the timeline editing process are
stored.
Values 1 to 10 (=0)
Default value 0 (page 10)
3.9.5. Playlist Settings
Introduction
The Playlist settings relate to various aspects of playlist management and effects.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦ on page 2 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Operational setup menu of the Remote Control Panel (3.X).
The following screenshot presents page 2 of the Operation tab in the server-based
application, where the Playlist settings are available, and highlights the Playlist settings
area:
Availability
The Playlist settings are only available if the license code 111 or 112 is valid. Some
playlist settings are tied to the code 112, and will therefore not be available if the license
code is not valid.
You can also create and manage playlist exclusively via protocols. In this case, the
playlist settings will not be available, and all playlist-related parameters will be defined by
the controlling application or device.
Video effect duration
Description Sets the duration of video transition effect. The specified value
is used as default value in the Playlist Edit mode.
Note that the duration of the video transition when using the
TAKE button in 1PGM+PRV mode has its own parameter,
Effect for take, defined in the EVS Controller section of the
Operation tab.
Values 0s00fr to 20s00fr
Default value 00s10fr
XT2+ Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 188