EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 121)

Mix on One Channel Settings
Introduction
The Mix on one channel settings allow specifying whether the secondary link of the codec
module (J3) of the play channel will be used to provide mixing with a single codec module.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Channels tab, in the advanced display mode:
◦ on page 5, 6 or 7 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Technical menu of the Remote Control Panel (T2.9).
Warning
The Mix on one channel settings are only available if the license code 31 is valid.
The following screenshot highlights the Mix on One Channel settings, defined on page 7 of
the Channels tab in the server-based application:
Mix on one channel
Description Enables/disables mixing on a single codec module, by means
of the secondary link of the codec module (J3) of a play
channel. This function applies to mixes in playlists, not in
timelines.
The license code 31 is required for the Mix on One Channel
feature to be available.
Mix on One Channel is available for all controllers (LSM
Remote panel or protocol), and with all codecs and resolutions,
except in 1080p and AVC-intra.
Values Yes / No (default)
111 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B