EVS XT2 Version 11.01 - November 2012 Configuration Manual - Manual (Page 149)

3.5.3. Gigabit Ethernet Settings
Introduction
The Gigabit Ethernet settings specify the settings related to the Gigabit Ethernet
network. It allows the backup and transfer of the audio and video data without going
through the SDTI network.
The Gigabit connection is provided via the HCTX board. Its backplane is equipped with
two Gigabit Ethernet ports. The settings need to be defined on at least one port for the
server to be able to operate the Ethernet connection.
When the Gigabit module is not present on the HCTX board or when the Gigabit
connection has been lost, the first line of the Gigabit Ethernet settings will display the
message !Not detected!.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Network tab, in the basic and advanced
display modes on page 1 in the server- and web-based interfaces.
• in the Technical menu of the Remote Control Panel (T3.X).
Warning
Changes to the Gigabit Ethernet parameters require an application reboot
(ALT+Q from the operational windows) to be applied.
The following screenshot highlights the Gigabit Ethernet settings, defined on page 1 of the
Network tab in the server-based application:
IP Address (Port 1/Port 2)
Description IP address to connect to the port #1/port #2 of the Gigabit
Ethernet connection on the EVS server.
Values The IP addresses 0.0.0.0 and 255.255.255.255 are not
allowed.
139 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B