EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 95)

Example: 3D/1080p Dual Link 3REC + 1PLAY
The BNC connectors to be used as recorder and play channels in a 3D or 1080p Dual Link
configuration 3REC + 1PLAY need to be cabled as shown below:
Note
In an equivalent configuration with a single link 3G interface, only the J8
connectors are cabled. However the primary and secondary links on the codec
module of the V3X board are both used.
3.2.7. 3D/1080p SLSM Configurations
Assignment Principles
The combination of 3D or 1080p standards and SLSM configurations associates the
following individual rules for connector assignments on the rear panel:
• For 3D or 1080p in Dual Link with V3X boards, the primary link of a codec module is
used for the first connector, and the secondary link for the same codec module is used
for the second connector.
• For 3D or 1080p in 3G (single link), only with V3X boards, the primary link of the codec
module is used for the single connector. However, both primary and secondary links
of a codec module of the V3X board are used.
• For the SLSM 2 Phase configurations, one SLSM recorder accounts for one logical
channel, but corresponds to two physical channels. This means that the primary
connectors of two codec modules will be used for one SLSM 2 Phase recorder.
• For the SLSM 3 Phase configurations, one SLSM recorder accounts for one logical
channel, but corresponds to three physical channels. This means that the primary
connectors of three codec modules will be used for one SLSM 3 Phase recorder.
85 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B