EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 68)

• The primary links of the V3X boards mentioned in the tables of this section correspond
to the upper connectors of a codec module.
◦ J8 for IN connectors
◦ J7 for OUT connectors (J6 is also equivalent to J7)
• The secondary links of the V3X boards correspond to the middle connectors of a
codec module:
◦ J5 for IN connectors
◦ J3 for OUT connectors
Channel Assignment in 2R/CM Configurations
With V3X boards, the 2R/CM configurations should be cabled in the following sequence:
1. Cable the play channels from left to right.
2. Cable the record channels from right to left starting with the primary links, without
using the left codec modules already cabled as play channels.
3. Cable the remaining record channels to assign starting from right to left, and using the
secondary link for the remaining codec modules.
XT3 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 58