EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 141)

Overview on Advanced Audio Settings
Introduction
The Advanced Audio settings are defined from the Channels tab, pages 3 to 6 of the
Multicam Configuration window. These pages are only available in the advanced mode.
They allow audio channel routing, muting, and adjusting the audio gain.
The Advanced Audio settings for the inputs allow users to specify how the audio sources
are routed to the audio mono channels of each record channel
The Advanced Audio settings for the outputs allow users to specify how the audio mono
channels are routed to each play channel (for embedded audio) or to the various physical
audio connectors (digital or analog connectors).
The table below shows in which page the advanced audio settings are available
depending on the audio type:
Page Type of audio settings
Page 3 audio inputs
Page 4 audio embedded outputs
Page 5 audio digital outputs (AES/EBU)
Page 6 audio analog outputs
Note
The settings for audio digital and analog outputs are only available when the
corresponding connectors are defined in the Audio Connectors field that
reflects the audio hardware configuration.
131 3. Multicam Configuration
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B