EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 251)

Glossary
2
2R/CM
Abbreviation standing for ‘2 record channels par codec module’. This feature allows using
the secondary link of the codec module of a recorder channel as an independent recorder
channel.
G
GPI
Abbreviation for General Purpose Interface. This refers to a device used as an
communication interface with the EVS server. It has digital lines which may be used for
input, output, or both, depending on the function.
H
Hypermotion camera
These are cameras that record at a frame rate much higher than real time. The content
recorded at high frame rate on a memory block of the camera buffer is ingested into the
EVS server through a single record channel when the operator initiates a play command
on the camera. Hypermotion cameras can be controlled by an LSM Remote Panel.
L
Logical channel
Logical player or recorder channel in a given configuration, independent from the physical
connections that have to be used to enable this logical channel.
M
Mix on One Channel
Feature that allows using the secondary link of the codec module of a player channel on
the V3X board (J3) as the preview channel to provide the PGM/PRV mode with a single
codec module.
Multicam Configuration window
Window in the server-based and web-based Multicam Setup application from where you
can define all configuration parameters.
Multicam Setup application
Term used to refer equally to the server-based or web-based user interface used to set up
and configure the EVS servers
241 Glossary
EVS Broadcast Equipment S.A. - November 2012 Issue 11.01.B