EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 112)

Warning
Some video formats allowed on an XT3 server create clips that are not
compatible with previous hardware. When an incompatible format is selected, a
warning will be issued at application startup. In addition, the video format
information displayed on the Server tab of the Multicam Configuration window
indicates any incompatible information.
3.3.3. Phase Definition Settings
Introduction
The Phase Definition settings are available on the Server tab in the server-based
application (1st page) and web-based interface in the advanced mode.
The Phase Definition settings are highlighted in the screenshot of the server-based
application shown below:
SD (Standard Definition)
Description Allows adjusting the digital main phase of the mainframe for
the standard definition. The value is adjusted by steps of half
pixels.
The values depends on the genlock type (See section "Video
and Reference Settings" on page 92).
Values • If the Genlock type is set to ‘Blackburst’, the main phase
for SD can be adjusted by steps of half pixels (37 ns)
between - 12000 ns and +15000 ns.
• If the Genlock type is set to ‘Tri-Sync’ (only possible in HD
resolutions), the main phase for SD can be adjusted by
steps of half pixels (37 ns) between - 30000 ns and
+32000 ns.
XT3 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 102