EVS XT3 Version 11.01 - November 2012 Configuration Manual - Manual (Page 244)

3.9.14. Hypermotion Controller Settings
Introduction
The Hypermotion controller settings allow specifying the settings related to the control of
a hypermotion camera from an LSM Remote Panel.
These fields are available in the following interfaces:
• in the Multicam Configuration window, Operation tab, in the basic display mode:
◦ on page 5 on the server-based application.
◦ on page 1 on the web-based interface.
• in the Operational setup menu of the Remote Control Panel (pages 11.X).
Warning
The hypermotion feature and settings are only available if the license code 20,
which allows controlling a hypermotion camera from the remote panel, is valid.
The following screenshot presents page 5 of the Operation tab in the server-based
application, where the Hypermotion controller settings are available, and highlights the
Hypermotion controller settings area:
Hypermotion
Description Enables or disables the hypermotion camera control feature.
When this setting is enabled, you can access and use the
hypermotion menu on the LSM Remote Panel via the
SHIFT+D key combination in the operational menu.
Values Yes / No
Default Values No
Recorder
Description Selects the record channel to which the A/V material from the
hypermotion camera will be sent.
Values CAM A to CAM D
Default Values The default value is the last CAM defined in the channel
configuration (for ex. CAM C in a 3 IN 3 OUT configuration).
XT3 Server - Version 11.01 - Configuration Manual
3. Multicam Configuration 234