Garmin APOLLO GX65 - Manual (Page 282)

Selecting
Frequencies
New frequencies are first selected as a Standby
frequency and then toggled to the Active side when
desired. While viewing the frequency display, use the
LARGE and SMALL knobs on the right side of the
GX60/65 to select the desired frequency. The Standby
frequency is highlighted (reversed).
1. Press COM to reach the Comm radio function. The
Smart keys will change to show the Comm
functions.
2. Turn the LARGE knob to change the Standby
frequency values in one MHz increments. The
MHz selection range is between 118 and 136 in one
MHz steps.
2. Turn the SMALL knob to change the Standby
frequency values in 25 kHz increments. The kHz
selection range is between 000 and 975 kHz in 25
kHz steps. Note that only two digits are displayed
to the right of the decimal point.
Turn the LARGE and SMALL knobs clockwise to
increase and counterclockwise to decrease the
frequency values. Standby frequency selection is not
inhibited during transmit.
Press the FLIP/FLOP key (internal or external) to
toggle the Standby or recalled frequency to the Active
frequency.
10-2
Comm Radio Operation