beautypg.com

Procedure turn at faf 9-22, Cdi reverse sensing 9-22, Procedure turn at faf -22 – Garmin APOLLO GX65 User Manual

Page 212

background image

2. Set the desired inbound course with the

LARGE

and

SMALL

knobs. Then, press

ENTER

.

OBS DTK: 000° to

BTG

ifaf

auto

brg 000

dtk 000

3. Verify that waypoint sequencing is set to “auto.”

4. Fly the procedure-turn or course reversal and

intercept the selected inbound course.

Note

While flying outbound, the CDI is reverse
sensing.

Many pilots are trained to set and fly the
outbound course in course reversal form to
eliminate reverse sensing of the CDI. In this
case, when you are prompted to set the OBS
course, enter the outbound course rather
than the inbound course as described
previously. During the procedure turn, press
DIR-TO twice and then set the inbound
course.

Enable Sequencing
As you intercept inbound course, the GX50/60 will
automatically enable sequencing and notify you with
a course intercept message when:

·

The Track Angle Error is

£45°

·

Cross Track Deviation is

£1 nm

Procedure

Turn at FAF

A special condition occurs when a procedure turn is
made at an IAF which is also the FAF. In this case,
the Apollo GX50/60 will treat the waypoint as the
IAF until sequencing is enabled when you are
established inbound.

When you enable sequencing by pressing the

OBS/HLD

key (OBS/HLD annunciator light turns

off), the IAF/FAF waypoint becomes the FAF. If you

9-22

Approach Basics (GX50/60)

ENTER

This manual is related to the following products: