Garmin G1000 Socata TBM 850 - Manual (Page 566)

Garmin G1000 Pilot’s Guide for the Socata TBM 850 190-00709-02 Rev. B
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EAS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
552
APPENDIX A
GWX 68 MESSAGE ADVISORIES
Message Comments
GWX CONFIG – GWX config error.
Config service req’d. GWX 68 configuration settings do not match those of the GDU configuration. The
G1000 system should be serviced.
GWX FAIL – GWX is inoperative. The GDU is not recieving status packet from the GWX 68 or the GWX 68 is reporting
a fault. The GWX 68 radar system should be serviced.
GWX SERVICE – GWX needs service.
Return unit for repair.
A failure has been detected in the GWX 68. The GWX 68 may still be usable.
WX ALERT – Possible severe weather
ahead. The GWX 68 indicates severe weather within ±10º of the aircraft heading at a range
of 80 to 320 nm.
MANIFEST – GWX software
mismatch, communication halted.
The GWX 68 has incorrect software installed. The G1000 system should be serviced.
GDC 74B MESSAGE ADVISORIES
Message Comments
ADC1 ALT EC – ADC1 altitude error
correction is unavailable.
GDC1 or GDC2 is reporting that the altitude error correction is unavailable.
ADC2 ALT EC – ADC2 altitude error
correction is unavailable.
ADC1 AS EC – ADC1 airspeed error
correction is unavailable.
GDC1 or GDC2 is reporting that the airspeed error correction is unavailable.
ADC2 AS EC – ADC2 airspeed error
correction is unavailable.
MANIFEST – GDC1 software
mismatch, communication halted.
The GDC 74B has incorrect software installed. The G1000 system should be serviced.
MANIFEST – GDC2 software
mismatch, communication halted.
GCU 475 MESSAGE ADVISORIES
Message Comments
GCU CNFG – GCU Config error.
Config service req’d. GCU 475 configuration settings do not match those of backup configuration memory.
The G1000 system should be serviced.
GCU FAIL – GCU is inoperative. A failure has been detected in the GCU 475. The GCU 475 is unavailable.
MANIFEST – GCU software mismatch,
communication halted.
The GCU 475 has incorrect software installed. The G1000 system should be serviced.
GCU KEYSTK – GCU [key name] Key
is stuck. A key is stuck on the GCU 475 bezel. Attempt to free the stuck key by pressing it
several times. The G1000 system should be serviced if the problem persists.