ACS ACR1283L - Manual (Page 32)

ACR1283L – Reference Manual [email protected]
Version 1.00 www.acs.com.hk
Page 32 of 55
5.4.2. Set Default LED and Buzzer Behaviors
This command is used to set the set the default behaviors for LEDs and Buzzer.
Set Default LED and Buzzer Behaviors Format (6 Bytes)
Command Class INS P1 P2 Lc Data In
Set Default LED and
Buzzer Behaviors
0xE0h 0x00h 0x00h 0x21h 0x01h
Default
Behaviors
Default Behaviors (1 Byte)
Default
Behaviors
Mode Description
Bit 0 RFU RFU
Bit 1 PICC Polling Status LED
To show the PICC Polling Status.
1 = Enable; 0 =Disable
Bit 2 PICC Activation Status LED
To show the activation status of the
PICC interface.
1 = Enable; 0 =Disable
Bit 3
Card Insertion and Removal
Events Buzzer
To make a beep whenever a card
insertion or removal event is detected.
1 = Enable; 0 =Disabled
Bit 4 - 6 RFU RFU
Bit 7 Card Operation Blinking LED
To make the LED blink whenever the
card is being accessed.
Note: Default value of Default Behaviors = 0x08h
Set Default LED and Buzzer Behaviors Response Format (6 Bytes)
Response Class INS P1 P2 Le Data Out
Result 0xE1h 0x00h 0x00h 0x00h 0x01h
Default
Behaviors