Acroprint TQ600F (software version 4.x and above) - Manual (Page 12)

8
Badge + Facial Verification
•
Swipe your badge over the swipe area to enter the 1:1 facial verification mode.
• Scan your face using the proper technique. For details, see 1.1 Standing Position, Posture
and Face Expressions .
• If the verification is successful, an interface as shown in Figure 3 on the right will be
displayed. The system will return to the Main Interface if the verification is not passed
within 20 seconds.
Badge + Password Verification
•
Swipe your badge over the swipe area.
• Enter password on key pad.
1.7.4 Combination Verification
The device supports up to 8 verification modes: FACE/RF/PW, FACE&PW, FACE&RF, PW, RF, FACE, PW/RF,
PW&RF. For the detail, please refer to 12.3 Multi-combination Authentication Mode .
Note : RF means proximity badge verification.
FACE/RF/PW verification:
Users can punch in/out by scanning their face or by scanning their badge or by entering their pin# & password.
Face Verification: Scan your face using the proper technique. For details, see 1.1 Standing Position, Posture and
Face Expressions . If the verification is successful, the display will show a punch in or out.
Badge Verification: Scan your badge. If the verification is successful, the display will show a punch in or out.
Password Verification: Press “1:1” on the Main Interface. Input your User ID (Pin#) & press the password button
(the Key icon). Enter your password and press “OK”. If the verification is successful, the display will show a punch in
or out.