Acroprint ATR360 Top Loading Time Card Recorder with Fingerprint & Proximity Badge User Verification - Manual (Page 9)

Page 6 of 26
Synchronizing the RTC to the System Clock
1. Open clock lid. Press "FP Setup" button
2. Press "down" until the LED display shows "rtc." Press "Enter"
Two sets of digits will be displayed. The first two digits sets the hour (00-23)
& the last two digits sets the minute (00-59). First set the hour to the current
hour. Next set the minute one minute ahead of the current time so that you
can sync the seconds as soon as the minute advances.
3. After setting the minute press "Enter" for 3 seconds. The two digit value for
seconds is displayed (00-59). Set the seconds at "00". Wait for the clock's
minute to roll forward, then press and hold "Enter" for 3 seconds. This will
synchronize the RTC to within a few seconds of the Clock Time. As long as
the RTC and Clock Time are set within a minute there shouldn’t be any
problems.
Note: if no buttons are pressed for 30 seconds the clock will exit fingerprint
settings. If you need more than 30 seconds for the minute to roll forward
you can press "Enter" to toggle between the seconds digits….this will reset
the 20 sec. time-out counter each time you press "Enter".
Setting Day Advance Time
16. The mode indicator “04” will be flashing, press P6 to select
17. Complete steps 11-15
Setting Pay Period
18. The mode indicator “05” will be flashing, press P5 to switch to mode “06”
19. The mode indicator “06” will be flashing, press P6 to select
20. Select the pay period type by pressing P4 or P5
a. If the pay period is monthly select 00
b. If the pay period is weekly select 01
21. Press P6 to save
22. To select the end of the weekly pay period you must select 07
23. Press P6 to save
Setting Clock Display Format
24. The mode indicator “07” will be flashing, Press P6 to select
25. Press P4 or P5 to select the clock display format
a. You can choose between the 12 hour or 24 hour (military time) format
26. Press P6 to save