Acroprint ATR360 Top Loading Time Card Recorder with Fingerprint & Proximity Badge User Verification - Manual (Page 24)

Page 21 of 26
Cleaning the ATR360
Do not use cleaning products that contain alcohol or other strong chemicals as they
could discolor or crack the terminal housing. Use a soft damp cloth to remove dirt.
Wipe dry.
Cleaning the Fingerprint Sensor
Caution: Do not use any cleaners on the sensor or it could be damaged.
If there is a fingerprint overlay on the fingerprint sensor you can do a quick clean by
lightly pressing a small strip of adhesive tape to the overlay and then slowly peel if off
to remove dust & dirt particles. You can also remove it and clean it with soapy water
then rinse and dry and re-attach to the sensor.
Clean the fingerprint sensor glass as follows:
1. Use a can of compressed air to blow off any loose dust or
dirt particles on the sensor.
2. Use a soft, lint free non-abrasive dry cloth to wipe the sensor surface. Be careful
not to scratch the surface of the sensor. If there are lint particles on the sensor
surface, use clear adhesive tape to remove particles. Place the clean overlay
over the sensor glass (if applicable).