RIDGID SeeSnake LT1000 - Manual (Page 15)

SeeSnake® LT1000
13
Connecting the LT1000
Connection Icons
The USB ports may be used to connect an external key-
board if desired.
The front AV out jack will work even when HQ is not
being used.
External Monitor Options
1. The LT1000 may be used with an external SeeSnake
monitor by connecting an RCA cable from the Vid-
eo IN port on the monitor. Connect the other end
of the cable to the LT1000 video OUT port on the
back of the LT1000, marked with .
2. The A/V out port will pass through live video
from the SeeSnake camera connected to the LT1000
and live audio from the microphone out to a DVDR
or monitor. (If connected to a monitor which has
speakers it may cause a feedback squeal; this can
be prevented by turning the DVDR or monitor vol-
ume to minimum.)
The USB connection from the LT1000 only functions
when connected to a device running SeeSnake HQ.
Powering the SeeSnake LT1000
The SeeSnake LT1000 can either be powered with a RIDGID
Li-Ion rechargeable battery or plugged into an outlet using
a supplied AC/DC power converter. Battery power is the
preferred powering method to reduce the risk of electrical
shock. Additionally, the power converter is not rated
for outdoor use and should only be used indoors.
WARNING Use only a battery or an isolated power
supply to power the LT1000 and any laptop used with
it to reduce the risk of Electrical shock.
Battery Power
With dry hands, insert a charged 18V battery into the
battery holder under the right side of the keypad. A
spare battery may also be stored in the spare battery
holder under the opposite end of the LT1000 on the
opposite side. (The storage slot has no electrical con-
nections and is for convenient storage only.)
Figure 22 – Alternate Configuration For Constrained
Spaces
Figure 23 – LT1000 Mini with Laptop
USB USB Video Out A/V Out
External
Power Jack
Figure 24 – LT1000 Connections
External Power Jack
A/V Out Jack (External DVDR, ect.)
Video Out Jack (External Monitor)
USB Port (Thumb Drivers, ect.)