ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 97)

ZyWALL IDP 10 User’s Guide
CLI Overview 9-3
Table 9-1 Commands Summary
COMMAND DESCRIPTION
stateful Enable/disable TCP state check
integrity Enable /disable TCP packet state
integrity using this command
tcptimeout Set the maximum TCP idle
timeout (this is how long a TCP
connection is allowed to remain
idle.
pinglen Set up maximum ping length
pingmax wan Set up maximum ping packet
accepted at wan port
lan Set up maximum ping packet
accepted at lan port
policy wan
Set up policy check on/off wan
port. Policy checks include both
user-defined and pre-defined
rules.
lan
Set up policy check on/off loan
port
Interface link wan 10
Set up wan port speed 10 at
full/half duplex
100
Set up wan port speed 100 at
full/half duplex
auto
Enable auto negotiation
lan 10
Set up lan port speed 10 at
full/half duplex
100
Set up lan port speed 100;
atfull/half duplex
auto
Enable auto negotiation
stealth wan Enable/disable stealth mode on
the wan port. Replies to outgoing
traffic are not allowed. When a
port is in stealth mode, you
cannot do remote management
nor policy checks on that port.
lan Enable/disable stealth mode on
thelan port
Remote snmp on
Enable remote snmp access from
LAN+MGMT/WAN+MGMT/MGMT
ONLY/ALL port
off Disable remote snmp access
acl Set up access control list ip
address
commnuity ro Set up community read only string