ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 94)

ZyWALL IDP 10 User’s Guide
8-12 Maintenance Screens
The ZyWALL will restart automatically after a configuration
restore is performed. Do not turn off the device while configuration
file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute before
logging into the device again.
The device automatically restarts in this time causing a temporary network disconnect.
If you uploaded the default configuration file you may need to change the IP address of your computer
to be in the same subnet as that of the default device IP address. See your Quick Start Guide for details
on how to set up your computer’s IP address.
If the upload was not successful, you will see a Restore configuration error screen.
8.5.3 Back to Factory Defaults
Pressing the Reset button in this section clears all user-entered configuration information, including
user-defined rules (nut not pre-defined rules) and returns the ZyWALL to its factory defaults as shown
on the screen. A warning screen appears first.
If you want to revert to factory default configurations (with no user-defined rules) AND clear all pre-
defined rules use the
reset all command from the console port.
8.6 Restart
Restart allows you to reboot the ZyWALL without turning the power off. Click MAINTENANCE,
and then Restart.. This does not affect the ZyWALL's configuration.
Figure 8-12 Maintenance: Restart