ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 96)

ZyWALL IDP 10 User’s Guide
9-2 CLI Overview
9.1.1 Help Facility
You can issue the help or help all command at any time. The system will display a list of
available commands in response.
9.2 Login
When you log in you will be prompted for the username (“admin”) and password (default is “1234”).
If you changed the password in the web configurator, then use that new password here. If the
password prompt appears before the username prompt, press until you are prompted for
the username. Then enter
admin (this is not changeable) followed by the password at the password
prompt followed by .
You will have to disable stealth on the LAN port or WAN port
before being allowed to manage the ZyWALL from that port.
9.3 Commands
The following table lists all of the commands that you can use with the ZyWALL.
Refer to the Support CD for detailed information on using
commands in the command line interface.
Table 9-1 Commands Summary
COMMAND DESCRIPTION
Set Log logmax Set the maximum number of logs
the device generates every
second
System passwd Set up the login password. This is
same password used for console,
SSH and web login.
system
timeout Set up the management idle
timeout
backup Back up configuration
restore Restore configuration
vlan id Set up vlan id
link Enable/disable vlan tag
ip address> Set up device ip address
mask Set up device subnet mask
gateway Set up device gateway ip address
detect vpnbypass Allow/disallow bypass of VPN
packets it doesn’t recognize.
portscan Allow/disallow port scanning
fragment Enable/disable fragment function