ZyXEL Communications ZyXEL ZyWALL IDP 10 - Manual (Page 26)

ZyWALL IDP10 User’s Guide
2-6 Introducing the Web Configurator
Table 2-2 Screens Summary
LINK TAB FUNCTION
Restart This screen allows you to reboot the ZyWALL without turning the power
off.
LOGOUT Click this link to log out of and exit the web configurator. For security
reasons, you should do this after each management session.
See the Quick Start Guide for information on using the wizard
to configure the ZyWALL for the first time.
2.4 Example Configuration Settings
The following table shows an example setup for your ZyWALL. In this setup, the ZyWALL is behind
a NAT router (or firewall) and is given a private IP address. The gateway is also in a private network.
The LAN and WAN ports are both in stealth mode and remote management is only allowed from the
MGMT port.
Table 2-3 Example Configuration Settings
ZyWALL Settings
IP Address 10. 10. 1.1 (private IP address)
Subnet Mask 255.255.255. 0
Gateway 10. 10. 1.254 (switch or router on LAN or DMZ)
State INLINE
Ports Settings
Port Link Status Stealth
WAN Auto 10M/Half UP ON
LAN Auto 100M/Full UP ON
MGMT Auto 100M/Full UP OFF
Remote Management:
WWW Server Access MGMT only
SNMP Server Access MGMT only
SSH Server Access MGMT only