beautypg.com

ZyXEL Communications ES-3148 Series User Manual

Page 81

background image

Chapter 7 Basic Setting

ES-3148 User’s Guide

81

Static IP

Address

Select this option if you don’t have a DHCP server or if you wish to assign static IP

address information to the Switch. You need to fill in the following fields when you select

this option.

IP Address

Enter the IP address of your Switch in dotted decimal notation for example 192.168.1.1.

IP Subnet

Mask

Enter the IP subnet mask of your Switch in dotted decimal notation for example

255.255.255.0.

Default

Gateway

Enter the IP address of the default outgoing gateway in dotted decimal notation, for

example 192.168.1.254.

VID

Enter the VLAN identification number associated with the Switch IP address. VID is the

VLAN ID of the CPU and is used for management only. The default is "1". All ports, by

default, are fixed members of this "management VLAN" in order to manage the device

from any port. If a port is not a member of this VLAN, then users on that port cannot

access the device. To access the Switch make sure the port that you are connected to

is a member of Management VLAN.

Out-of-band Management IP Address

IP Address

Enter the IP address of your Switch in dotted decimal notation for example 192.168.0.1.
If you change this IP address, make sure the computer connected to this management

port is in the same subnet before accessing the Switch.

IP Subnet

Mask

Enter the IP subnet mask of your Switch in dotted decimal notation for example

255.255.255.0.

Default

Gateway

Enter the IP address of the default outgoing gateway in dotted decimal notation, for

example 192.168.0.254.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses

these changes if it is turned off or loses power, so use the Save link on the top

navigation panel to save your changes to the non-volatile memory when you are done

configuring.

Cancel

Click Cancel to reset the fields.

In-band IP

Addresses

You can create up to 64 IP addresses which are used to access and manage the Switch

from the ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.

IP Address

Enter the IP address for managing the Switch by the members of the VLAN specified in

the VID field below.

IP Subnet

Mask

Enter the IP subnet mask in dotted decimal notation.

VID

Type the VLAN group identification number.

Default

Gateway

Enter the IP address of the default outgoing gateway in dotted decimal notation.

Manageable

Select this option to allow the Switch to be managed using this specified IP address.

Add

Click Add to save the new rule to the Switch’s run-time memory. It then displays in the

summary table at the bottom of the screen.

Cancel

Click Cancel to reset the fields.

Index

This field displays the index number of an entry. Click an index number to edit the rule.

IP Address

This field displays the IP address.

IP Subnet

Mask

This field displays the subnet mask.

VID

This field displays the VLAN identification number of the network.

Default

Gateway

This field displays the IP address of the default outgoing gateway.

Table 12 Basic Setting > IP Setup (continued)

LABEL

DESCRIPTION