beautypg.com

1 console port, 2 external backup power supply connector, Figure 14 rear panel – ZyXEL Communications ES-3148 Series User Manual

Page 46: Table 2 rear panel

background image

Chapter 3 Hardware Overview

ES-3148 User’s Guide

46

Figure 14 Rear Panel

The following table describes the ports on the panels.

3.2.1 Console Port

For local management, you can use a computer with terminal emulation software configured
to the following parameters:

• VT100 terminal emulation
• 9600 bps
• No parity, 8 data bits, 1 stop bit
• No flow control

Connect the male 9-pin end of the console cable to the console port of the Switch. Connect the
female end to a serial port (COM1, COM2 or other COM port) of your computer.

3.2.2 External Backup Power Supply Connector

The Switch supports external backup power supply (BPS).

RJ-45 Gigabit Ports for Stacking

Console Port

Management Port

External BPS

Power Receptacle

Table 2 Rear Panel

CONNECTOR

DESCRIPTION

2 100/1000

Mbps RJ-45

Ports

Connect these ports to high-bandwidth backbone network Ethernet switches or use

them to daisy-chain other switches.

Console Port

Only connect this port if you want to configure the Switch using the command line

interface (CLI) via the console port. See

Section 3.2.1 on page 46

.

Management

Port

Connect to a computer using an RJ-45 Ethernet cable for local configuration of the

switch.

External

Backup Power

Supply (BPS)

Connect this to an external BPS. See

Section 3.2.2 on page 46

.

Power

Receptacle

Connect this to an appropriate power supply. See

Section 3.2.3 on page 47

.