beautypg.com

Figure 142 management > access control > logins, Table 105 management > access control > logins – ZyXEL Communications ES-3148 Series User Manual

Page 254

background image

Chapter 30 Access Control

ES-3148 User’s Guide

254

• A non-administrator (username is something other than admin) is someone who can view

but not configure Switch settings.

Click Management > Access Control > Logins to view the screen as shown.

Figure 142 Management > Access Control > Logins

The following table describes the labels in this screen.

Table 105 Management > Access Control > Logins

LABEL

DESCRIPTION

Administrator
This is the default administrator account with the “admin” user name. You cannot change the default

administrator user name. Only the administrator has read/write access.

Old Password

Type the existing system password (1234 is the default password when

shipped).

New Password

Enter your new system password.

Retype to confirm Retype your new system password for confirmation

Edit Logins
You may configure passwords for up to four users. These users have read-only access. You can give

users higher privileges via the CLI. For more information on assigning privileges see the CLI Reference

Guide.

User Name

Set a user name (up to 32 ASCII characters

long).

Password

Enter your new system password.

Retype to confirm Retype your new system password for confirmation

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch

loses these changes if it is turned off or loses power, so use the Save link on

the top navigation panel to save your changes to the non-volatile memory when

you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.