ZyXEL Communications ES-3148 Series - Manual (Page 223)

ES-3148 User’s Guide
223
C
H A P T E R
26
Static Routing
This chapter shows you how to configure static routes.
26.1 Configuring Static Routing
The Switch uses IP for communication with management computers, for example using
HTTP, telnet, SSH, or SNMP. Use IP static routes to have the Switch respond to remote
management stations that are not reachable through the default gateway. The Switch can also
use static routes to send data to a server or device that is not reachable through the default
gateway, for example when sending SNMP traps or using ping to test IP connectivity.
Click IP Application > Static Routing in the navigation panel to display the screen as shown.
Figure 117 IP Application > Static Routing
The following table describes the related labels you use to create a static route.
Table 84 IP Application > Static Routing
LABEL DESCRIPTION
Active This field allows you to activate/deactivate this static route.
Name Enter a descriptive name (up to 10 printable ASCII characters) for identification
purposes.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use
a subnet mask of 255.255.255.255 in the subnet mask field to force the network
number to be identical to the host ID.
IP Subnet
Mask
Enter the subnet mask for this destination.