2 arp inspection log status – ZyXEL Communications ES-3148 Series User Manual
Page 213

Chapter 24 IP Source Guard
ES-3148 User’s Guide
213
Figure 107 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
The following table describes the labels in this screen.
24.6.2 ARP Inspection Log Status
Use this screen to look at log messages that were generated by ARP packets and that have not
been sent to the syslog server yet. To open this screen, click Advanced Application > IP
Source Guard > ARP Inspection > Log Status.
Table 78 Advanced Application > IP Source Guard > ARP Inspection > VLAN Status
LABEL
DESCRIPTION
Show VLAN range
Use this section to specify the VLANs you want to look at in the section
below.
Enabled VLAN
Select this to look at all the VLANs on which ARP inspection is enabled in
the section below.
Selected VLAN
Select this to look at all the VLANs in a specific range in the section below.
Then, enter the lowest VLAN ID (Start VID) and the highest VLAN ID (End
VID) you want to look at.
Apply
Click this to display the specified range of VLANs in the section below.
VID
This field displays the VLAN ID of each VLAN in the range specified above.
Received
This field displays the total number of ARP packets received from the
VLAN since the switch last restarted.
Request
This field displays the total number of ARP Request packets received from
the VLAN since the switch last restarted.
Reply
This field displays the total number of ARP Reply packets received from
the VLAN since the switch last restarted.
Forwarded
This field displays the total number of ARP packets the switch forwarded
for the VLAN since the switch last restarted.
Dropped
This field displays the total number of ARP packets the switch discarded
for the VLAN since the switch last restarted.