O - hardware options 3-73, Command - hardware options -73 – Zebra Technologies EPL2 User Manual
Page 91

O Command - Hardware Options
Description Use this command to select various printer op-
tions. Options available vary by printer
configuration.
Syntax
O[C[p
1
], D, P, L, S]
Parameters
D
= Enable Direct Thermal Mode, use this
option when using direct thermal media
in a thermal transfer printer.
P
= Enable Label Dispense Mode -
Portables
L
= Enable Label Dispense Mode - Tap
to Print. The printer will present each
label and wait for a tap of the feed
switch before printing the next label.
Use this mode when printing multiple
copies of liner-free labels.
C
= Enable optional Label Liner Cutter.
The cutter will cut at the end of each
form as specified by the
Q
command.
Cp
1
= Batch Print Labels and Liner Cut.
p
1
= Sets the number of labels to print
prior to cut.
If a number between 1 - 255 is specified
for
p
1
, the printer will cut after the spec-
ified number of labels have been
printed.
If
b
is specified for
p
1
, the “batch print
& cut” feature is enabled. This feature
uses the
P
command to control cutter
operation.
S
= Reverse the Transmissive (Gap) Sen-
sor Operation.
980352-001 Rev.A
3-73