Zebra Technologies EPL2 - Manual (Page 87)

oR Command - Character Substitution (Euro)
Description This command allows the advanced program-
mer to substitute the Euro currency character
for any ASCII character in printer resident font
numbers 1-4.
The original character can be restored by send-
ing the oR command without a parameter.
Syntax oR [ p
1
, p
2
]
Parameters: p
1
= E
If the p
2
parameter is not provided,
then the Euro character will map to
code page position 213 decimal (D5
hexadecimal) for all code pages.
p
2
= Decimal number
Range: 0 to 255
The active code page’s ASCII character
map position to be replaced by the Euro
character. The Euro character will be ac-
tive in this map position for all code
pages.
See the I command for details on code
page selection.
None = No Parameters ( p
1
/ p
2
) resets to all
code pages to original default character
mapping.
Optionally, to reapply normal character opera-
tions, issue a o (111 dec. or 6F hex.) command.
See page 3-63 for important details on the ef-
fects of using the o command.
The Euro character is not supported in Font 5 char-
acter set.
980352-001 Rev.A
3-69