Zebra Technologies EPL2 - Manual (Page 122)

V Command - Define Variable
Use this command in forms that require unique
data on each label. When initializing variables:
· They must be defined in order (e.g. V 00 first,
V 01 second...)
· They must be the next entries after the
FS"FORMNAME" command
· They must be located before any counter
variables.
To print the contents of the variable, the vari-
able number is referenced in the “DATA” field
of the A (ASCII text) or B (Bar Code) com-
mands.
The field justification parameter effects the way
the variable will be printed. When L of R are se-
lected, the variable value will be printed left or
right justified in an area with a width defined by
p
2
parameter.
The maximum amount of data stored as variable
data, including counter variables and data reference
overhead can not exceed 1500 bytes.
KDU Support: Internally stored variable data fields
are reset after cycling printer power or sending a re-
set command or pressing the Cancel.
Example: V00,15,N,"Enter Product Name:" ¿
3-104
980352-001 Rev.A