Zebra Technologies EPL2 - Manual (Page 117)

UP Command - Codepage & Memory Inquiry/Print
Description This command will cause the printer to print
and send the currently selected codepage and
memory status to the host through the
RS-232 port.
This command also disables software flow con-
trol (XON/XOFF). Hardware flow control is not
disabled (DTR/CTS). To restart software flow
control a reset ( ^@ command) or power must
be recycled.
Syntax UP
The printer will send information about the cur-
rently selected code page and memory status
back to the host followed by printing the current
printer configuration. For an example of the
configuration printout, see the U command.
The format of data sent to the host is as follows:
UPp
1
,p
2
,p
3
,p
4
,p
5
,p
6
,p
7
,p
8
,p
9
p
1
= Image buffer size in KBytes.
p
2
= Form memory allocation size in KBytes.
p
3
= From memory free in KBytes.
p
4
= Graphic memory allocation size in
KBytes.
p
5
= Graphic memory free in KBytes.
p
6
= External font memory allocation size in
KBytes.
p
7
= External font memory free in KBytes.
p
8
= Appends a response in the UI com-
mand data format. See UI command on
page 3-96.
Example: UP ¿
See Also I , M , U , UI and UM commands.
980352-001 Rev.A
3-99