Zebra Technologies EPL2 - Manual (Page 114)

UI Command - Host Prompts/Codepage Inquiry
Description This command will cause the printer to enable
prompts to be sent to the host and it will send the
currently selected codepage to the host through
the RS-232 port.
This command also disables software flow con-
trol (XON/XOFF). Hardware flow control is not
disabled (DTR/CTS). To restart software flow
control a reset ( ^@ command) or power must
be recycled.
Syntax UIp
1
, p
2
, p
3
The printer will send information about the cur-
rently selected code page back to the host in the
following format:
p
1
= Number of data bits.
p
2
= Code page.
p
3
= Country code.
The KDU automatically sends this command each
time power is applied.
Example: UI ¿
See Also: I and U commands.
3-96
980352-001 Rev.A