Zebra Technologies EPL2 - Manual (Page 50)

eR Command - User Defined Error/Status Character
Description: This command allows the advanced program-
mer to specify the printer's error/status report
character for error reporting via the RS-232 se-
rial interface.
Syntax: eRp
1
, p
2
Parameters: p
1
= Any single ASCII character
Range: 0-255 decimal (00-FF hexadeci-
mal)
p
2
= Error/Status Response Mode
p2 Mode Descriptions
0
Standard (default):
XON (17 dec. / 11 hex.) on Recovery
XOFF (19 dec. / 13 hex.) on Error
1
Character Only:
Reports the selected error/status character
followed by a Carriage Return and Line Feed.
2
Character & Error/Status Code:
Reports the selected error/status character, er-
ror/status code (see page 3-112 for codes),
and then by a Carriage Return and Line Feed.
Example: For Mode 2 Error and Status Reporting:
eR$,2 ¿ : Sets Error Character to "$" and
: Sets Error Mode to "2".
: User operates and prints with printer.
: User opens print head.
$11 ¿ : Reports Print Head Open
: User closes print head
$00 ¿ : Reports No Error
: Printer Ready for next command.
: (Status report for Print Head Closed)
3-32
980352-001 Rev.A