Ce mark, Emc information – Xerox Phaser 3635 User Manual
Page 17
1
Welcome
Xerox Phaser 3635 User Guide
11
This product has been manufactured under a registered ISO9001 Quality system.
CE Mark
The CE mark applied to this product, symbolizes XEROX's declaration of
conformity with the following applicable European Union Directives, as of the
dates indicated:
December 12, 2006:
Council Directive 2006/95/EC as amended. Approximation of the laws of the
member states related to low voltage equipment.
December 15, 2004:
Council Directive 2004/108/EC as amended. Approximation of the laws of the
member states related to electromagnetic compatibility.
March 9, 1999
Council Directive 99/5/EC, on radio equipment and telecommunications
terminal equipment and the mutual recognition of the conformity.
A full declaration of conformity, defining the relevant directives and referenced
standards, can be obtained from your XEROX Limited representative.
WARNING:
In order to allow this equipment to operate in proximity to
Industrial Scientific and Medical (ISM) equipment, the external radiation from
the ISM equipment may have to be limited or special mitigation measures
taken.
NOTE:
Changes or modifications to this equipment not specifically approved by
the Xerox Corporation may void the user’s authority to operate this equipment.
WARNING:
Shielded cables must be used with this equipment to maintain
compliance with Council Directive 2004/108/EC.
EMC Information
FCC Part 15
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interferences at
their own expense.